Capacity
All power take-offs are particularly designed for generating hydraulic pumps to SAE J744C series ‘B’ specification with splined insight shaft and either two-bolt or four-bolt fixing. The maximum power which may be transmitted is 22 KW (29.5 bhp) per 1000 rev/min engine speed; this equates to a torque of 209 Nm (155 Ibf.ft. – 21.33 kgm.).For PRM1000 the clutched power take-off gives pump 
rotation exactly like the engine, where as the direct drive power take-off for the PRM500 and PRM750 gives opposite rotation. Capacity to the pump isn’t affected by the normal utilization of the gearbox for propulsion duties. All ancillary power circuits powered by PRM power take-offs ought to be designed relative to the recommendations of the hydraulic tools manufacturer, and really should be correctly safeguarded against overloading.
Installation
PRM power take-off units fit on the trunk face of the primary gearcase and so are driven by the input shaft; consequently they may be operated at all times whilst the engine is usually running, The energy take-off replaces the end cover which is generally fitted and performs the features of the end cover by sealing the gearbox against lack of oil and properly positions the insight shaft back bearing. Power take-off systems also provide the link between your gearbox and the hydraulic pump.
Direct Drive Power Take-Off
Available on the PRM500 and PRM 750 the direct drive power take-off is definitely driven directly from the gearbox input shaft; consequently it’ll operate all the time when the engine can be operating, and since there is no clutch for disengagement of the hydraulic pump, provision should be made in the auxiliary hydraulics circuits for pressure by-move to the reservoir when capacity to the pump is not needed. A set of 1:1 ratio gears, providing enough offset between your gearbox result shaft and the centreline of the power take-off to make sure there is enough clearance between the hydraulic pump and propeller shaft coupling.
Specifications
Ever-Power PTO Shaft
Series 6
1-3/8 inch 6-spline tractor end yoke and a 1-3/8 inch 6-spline FD2 clutch on the implement end
FD2 clutch
Collapsed length: 47 in.
Prolonged length: 60 in.
62 HP at 540 RPM
98 HP at 1000 RPM
FD2 clutch attaches with one bolt that matches a groove on input shaft of rotary mower
Obtain the crucial info you need about PTO gearbox by visitng our website currently.